Please pay attention to the main points of mirror axis processing. Next, the small series of Longfeng Machinery will be introduced in detail for everyone, as follows. I hope to help everyone!

1. In order to simplify positioning and safety, each positioning surface of the fixture should have an accurate coordinate size with respect to the machining origin of the machining center.

2. In order to ensure the direction of the part installation and the direction of the workpiece coordinate system and machine coordinate system selected in the programming, as well as positioning and installation.

3. It can be disassembled for a short time to make it suitable for new workpieces. Since the auxiliary time of the machining center is compressed to be very short, the loading and unloading of the supporting jig cannot take up too much time.

4. The fixture should have as few components as possible and higher stiffness.

5. The fixture should be as open as possible. The spatial position of the clamping element should be low or low. The fixture installation does not interfere with the tool path.

6. Ensure that the machining content of the workpiece is completely completed within the stroke area of the spindle.

7. For machining centers with interactive workbenches, the fixture design must prevent spatial interference between the fixture and the machine due to movement, upper support, lower support, and rotation of the table.

8. Try to complete all the processing in one clip. When it is necessary to replace the clamping point, special care should be taken not to damage the positioning accuracy due to the replacement of the clamping point. If necessary, it should be stated in the process documentation.

9. When the bottom of the fixture touches the workbench, the bottom flatness of the fixture must be between 0.01-0.02Mm, and the surface roughness should not be greater than Ra3.2μm.

       The above is the relevant information introduced by the small editor of the mirror axis processing factory. If you need more information, please contact us!